Solenoid Dosing Pumps
With Built-In Controllers
FX & MX Series Dosing Pumps + Controller
- Foot and wall mounting
- Range : 1 lph @ 0.5 bar - 22 lph @ 2 bar
- Parameters : pH measuring range 0-14 pH (resolution 0,01pH), RX measuring range -1000 to +1400 mV (resolution 1mV), Free or Total chlorine*: range: 0÷20,00 ppm (resolution 0,1ppm) [ suitable either with membrane-potentiostatic Chlorine sensors or open amperometric chlorine cells
- Injection frequency adjustment, Stroke length adjustment (FX only)
- 2 Reset modes: - full reset - partial reset keeping calibration settings
- ON-OFF and Proportional modes
- Delay adjustment - Delay at powering ON (for electrodes polarization)
- Setting for proximity switch to stop operation in case of no water
- 4-20 mA output for chart recorder with calibration of mA output
CTRL DUAL - MXE Series Dosing Pumps + Dual Controller
- Suitable for where continuous duty is not required.
- Range : 5 lph @ 5 bar, adjustable
- Parameters : pH and RX (ORP), free chlorine, PH range: 0-14; Resolution pH +/- 0,01; REDOX range 0-1000 mV; Resolution +/- 1 mV, PH priority over RX measurements
- ON-OFF mode; Timed pulses mode (PWM) start/stop mode
- PWM / timed pulses activating point: 1.50 pH / 150 mV
- Temperature measurements
- 2 Level controls of chemical tanks
- 485 communication between measuring unit – transmitter
- Simultaneous measurements : Level control, Alarm, Flow sensor, unit operating status
- Universal power supply 90-240 Vac (option of 12-24 Vdc)
